Changing The Presser Foot; Needle Area; Needle Holder - Bernina L 890 User Manual

Setting up the machine

Changing the presser foot

Prerequisite:
•
•
> Press the release button on the rear side of the presser foot shaft.
> Lift the presser foot spring slightly and remove the presser foot.
> Lift the presser foot spring slightly and place the new presser foot beneath the shaft groove so that the
> Lower the presser foot shaft carefully until the shaft groove engages with the presser foot pin.
> Raise the presser foot.

3.5 Needle area

Needle holder

The needle holder can hold five needles. The machine is designed for needles of the ELx705 system. Needle
sizes between 70 − 90 are to be used for this machine. (see page 63)
44
The needles are in the top position.
The presser foot is raised.
– The presser foot is released.
shaft groove lies exactly above the presser foot pin.