Bernina L 890 User Manual page 35

Manual settings
This overview shows which manual settings must be made for the selected stitch. All settings listed here
must be checked and executed to be able to sew the selected stitch.
1 3
2
7
6
8
10 11
Note
1 «Presser foot»
2 «Upper looper converter»
3 «Knife on/off»
4 «Cutting width»
5 «mtc micro thread control»
6 «Presser foot pressure»
7 «Upper looper on/off»
8 «Knife cover insert/coverstitch insert»
9 «Rolled hem selection lever O/R»
10 «CS-needles»
11 «OL-needles»
12 «Cancel»
13 «Confirm»
14 «Wizard»
4
5
9
12 13
14
Description
Indicates the presser foot recommended for the
stitch. (see page 44)
Indicates whether the upper looper converter is
hooked in or hooked out. (see page 77)
Indicates the necessary position of the knife. (see
page 74)
Indicates the recommended cutting width. (see
page 75)
Indicates the recommended default value of the mtc
micro thread control. (see page 84)
Indicates the value of the presser foot pressure. (see
page 85)
Indicates the required position of the upper looper.
(see page 76)
Indicates the required insert. (see page 74)
Indicates the position of the rolled hem selection
lever. (see page 83)
Show the needlepositions to be used for the
corresponding stitch. (see page 44) (see page 45)
Show the needlepositions to be used for the
corresponding stitch. (see page 44) (see page 45)
Closes the screen «manual settings» and switches to
stitch view.
Closes the screen «Manual settings» and switches to
the view of actual stitch in the «Stitch view».
Starts «step-by-step instruction» through the manual
settings that must be made or controlled for the
selected stitch.
My BERNINA overlocker
35