Interface Dialer - H3C SecPath Series Command Manual

Command Manual – User Access
H3C SecPath Series Security Products
1 164
2 304
For more details of the display information, see the following table.
Table 3-2 Explanation of the information displayed by pppoe-client session packet
Field
ID
InP
InO
InD
OutP
OutO

3.1.8 interface dialer

Syntax
interface dialer number
undo interface dialer number
View
Any view
Parameter
number: Interface number in the range of 0 to 1,023.
Description
Use the interface dialer command to create a dialer circular group for the Circular
DCC, or configure a dialer interface for the Resource-Shared DCC.
Use the undo interface dialer command to cancel the existing setting.
By default, no dialer interface is defined.
In Circular DCC, dialer circular group function can apply the configuration of a dialer
interface to a group of physical interface, so that they can inherit the attributes of the
dialer interface. This method is very useful in calling multiple destination addresses:
configure multiple dialer route commands on the dialer interface and just the dialer
circular-group command on each physical interface.
In Resource-Shared DCC, any dialer interface can use the services provided by
multiple physical interfaces, and individual physical interfaces can provide services for
multiple dialer interfaces at the same time. Therefore, authentication must be
Chapter 3 PPPoE Client Configuration Commands
6126 0
9886 0
Session ID, PPPoE session ID
In Packets: number of received packets
In Octets: number of received octets
In Discards: number of received illegal and discarded packets
Out Packets: number of sent packets
Out Octets: number of sent octets
3-7
83 1069
156 2142
Explanation
0
0