Debugging Ppp { Core | Ip | Ipcp | Lcp | Lqc | Mp - H3C SecPath Series Command Manual

Command Manual – User Access
H3C SecPath Series Security Products

1.1.3 debugging ppp { core | ip | ipcp | lcp | lqc | mp }

Syntax
debugging ppp { core event | ip packet-| ipcp { all | event | error | packet | state } |
lcp { all | event | error | packet | state } | lqc packet | mp { all | event | error |
packet } } [ interface interface-type interface-number ]
undo debugging ppp { core event | ip packet| ipcp { all | event | error | packet |
state } | lcp { all | event | error | packet | state } | lqc packet | mp { all | event | error
| packet } } [ interface interface-type interface-number ]
View
User view
Parameter
core event: Enable PPP core event information debugging.
ip packet: Enable PPP IP packet debugging.
ipcp: Enable PPP IP control protocol debugging.
lcp: Enable PPP network control protocol debugging.
lqc packet: Enable PPP link quality control protocol debugging.
mp: Enable PPP multi-link protocol debugging.
all: Enable all debugging switches.
event: Enable event information debugging.
error: Enable error information debugging.
packet: Enable packet information debugging.
state: Enable state information debugging.
interface interface-type interface-number: Interface type and interface number.
Description
Use the debugging ppp { core | ip | ipcp | lcp | lqc | mp } command to enable the
CORE, IP, IPCP, ICP, IQC, or MP debugging switch of PPP.
Use the undo debugging ppp { core | ip | ipcp | lcp | lqc | mp } command to restore
the default debugging setting.
By default, all PPP debugging switches are disabled.
Example
None
Chapter 1 PPP Configuration Commands
1-3