I Additional Menus - Zodiac Heat Select ZS500 Series Instructions For Installation And Use Manual

Display
Error 12
ST5 sensor error
compressor discharge
sensor
Error 13
ST4 sensor fault fluid line
sensor
Error 14
ST1 sensor fault water
intake sensor

4.3 I Additional menus

To access the menu, press
To browse the menus and modify the values, press
To validate a selection, press
To go back in the menus, press
Values provided for information purposes, factory settings
Possible causes
Sensor is faulty or offline (J13
connector)
Sensor is faulty or offline (J16
connector)
Sensor is faulty or offline (J46
connector)
.
or
.
(only accessible to professionals)
Only accessible to professionals
Solutions
Reconnect or change the sensor Press
Reconnect or change the sensor Press
Reconnect or change the sensor Press
Water temperature on intake
Air temperature
Defrost sensor
Fluid line sensor
Compressor discharge temperature
Compressor operating speed
Ventilator operating speed
Opening of electronic valve
Temperature set point
Hysteresis to switch to cooling mode in
relation to the setpoint
Calibration of the ST1 water intake sensor
Calibration of the ST2 air intake sensor
Cooling mode activation
Fixed operating hours counter
Counter with operating hours reset
Activation of continuous screen backlighting
Activation of heating priority mode
"ON" operation of the filtration pump (if P50
= 3)
"OFF" operation of the filtration pump (if P50
= 3)
Resetting
EN
14