Complete The Assembly; Install On/Off Switch - Vermont Castings Stardance SDV30 Installation And Operating Manual

Direct vent/natural vent gas heater

Hide thumbs Also See for Stardance SDV30:

Homeowner's installation and operating manual (44 pages)

Table Of Contents

Table of Contents

8. The air shutter is located on the bottom of the burner

to the left. Unfasten the two nuts holding the shutter

in place. The shutter may be adjusted between the

factory adjusted 1/2" to fully open. Reassemble the

shutter to allow the rear injector air inlet to close from

the minimum 1/2" opening to fully open. (Fig. 39) You

may have to try more than once to ﬁnd the correct air

shutter opening for best results depending on your

altitude.

Refer to

Table 1

Fig. 38 Air shutter in original from-the-factory position.

Front Injector

Air Inlet

Rear Injector Air Inlet

Fig. 39 Air shutter adjusted.

9. Refasten the two nuts and assemble the burner into

the unit by sliding the burner in at an angle with the

left side lower than the right side. Slide the left side

onto the injectors. Lower the right hand side down

into place. Make sure the burner is as far left as pos-

sible and the injector shoulders are inside the burner.

NOTE: It is very critical to keep the left burner leg,

which holds the injectors, at a 90° angle to the base.

(Fig. 40) This keeps the oriﬁces aligned with tubes

on the inside of the burner. Failure to do so could

affect the ﬂame appearance and performance of the

unit.

10.Refasten the right and left log bracket assembly.

11.Refasten the rear log bracket.

12.Replace logs.

13.Replace glass and stove front.

Follow lighting instructions on Page 25. Check ﬂame

color appearance. NOTE: Allow stove to burn for at

least 1/2 hour to establish full ﬂame color.

Should color need further adjustment, repeat steps 1

- 12 for air shutter adjustment.

20007065

Air Shutter

(Original Position)

Burner

Air Shutter

ST352

(May be adjusted up to fully open)

jefferson

Burner

air shutter

new position

3/20/00 djt

ST351

jefferson

air shutter

original position

3/20/00 djt

Stardance Direct Vent/Natural Vent Gas Heater

Fig. 40 Be sure to maintain 90° angle at left burner leg.

• Open the swiveling latches (cams) on the top left and

right corners of the glass frame.

• Position the glass and frame against the ﬁrebox by

placing the bottom edge on the brackets on the bot-

tom face of the ﬁrebox.

ST352

• Swing the assembly against the ﬁrebox, and close

the latches ﬁrmly against the pins protruding from the

ﬁrebox top.

The switch assembly parts are found in the parts bag.

1. Attach switch assembly to left rear side of stove

shroud (when facing shroud) using two screws and

existing holes in shroud. (Fig. 41)

2. Run wires down back of stove, under bottom of rear

shroud to valve.

3. Attach wires to valve terminals. (Fig. 42)

Switch

Assembly

Screws

Fig. 41 Attach switch assembly to rear shroud.

Fig. 42 Attach switch wires to valve.

Left Burner Leg

Injector Shoulder

90°