Power Trim And Tilt Unit Will Not Operate - Yamaha VF200 Owner's Manual

Trouble Recovery
5. Fuel feed pump fuse (10 A)
6. Electric throttle valve fuse (10 A)
7. Main switch / PTT switch fuse (20 A)
8. Main fuse (60 A)
3
1. Fuse box cover
2. Fuse puller
3. Spare fuse (10 A, 15 A, 20 A, 30 A)
4. Spare main fuse (60 A)
1
1. Fuse puller
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU40984
Power trim and tilt unit will not
operate
EWM02331
WARNING
Never get under the engine while it is tilt-
ed. Severe injury could occur if the out-
102
2
1
ZMU08319
ZMU08320
board motor accidentally falls.
If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure
with the power trim and tilt unit, the outboard
motor can be tilted manually.
1. Stop the engine.
2. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
VF200LA, VF225LA, VF250LA
4
1. Manual valve screw
VF250XA
1. Manual valve screw
3. Tilt the outboard motor up manually to
the desired position, and then tighten the
manual valve screw by turning it clock-
wise.
1
ZMU06962
1
ZMU07196