Checking Power Trim And Tilt Unit - Yamaha VF200 Owner's Manual

Operation
EMU46180

Checking power trim and tilt unit

EWM04270
WARNING
Never get under the lower unit while it

is tilted, even when the tilt support
shaft is installed or the tilt support lever
is locked. Severe injury could occur if
the outboard motor accidentally falls.
Body parts can be crushed between the

outboard motor and the clamp bracket
when the outboard motor is trimmed or
tilted.
Make sure that no one is near the out-

board motor before performing this
check.
1. Check the power trim and tilt unit for fluid
leakage.
2. Operate each of the power trim and tilt
switches on the bottom cowling and re-
mote control lever to check that all
switches work.
56
UP
DN
1. Power trim and tilt switch
UP
DN
1
1. Power trim and tilt switch
3. Tilt the outboard motor up and check
that the tilt rod and trim rods are extend-
ed completely.
ZMU06969
1
2
1. Tilt rod
2. Trim rods
4. Check that the tilt rod and trim rods are
1
ZMU06907
ZMU06981
ZMU06923