Treatment Of Submerged Outboard Motor - Yamaha VF200 Owner's Manual

Trouble Recovery
tion could occur.
1. Water detection switch coupler
5. Remove the filter cup from the filter
housing, and then remove the O-ring
from the filter cup. NOTICE: Be careful
not to twist the water detection
switch lead when unscrewing the fil-
ter cup.
[ECM01961]
1
2
3
4
1. Filter housing
2. O-ring
3. Filter cup
4. Water detection switch lead
6. Drain the water in the filter cup by soak-
ing it up with a rag.
7. Put the O-ring on the filter cup in its orig-
inal position, and then install the filter
cup onto the filter housing. NOTICE: Be
careful not to twist the water detec-
tion switch lead when screwing the
104
[ECM01951]
1
ZMU07520
ZMU07521
filter cup onto the filter housing.
[ECM01971]
1
2
3
1. O-ring
2. Filter cup
3. Water detection switch lead
8. Connect the water detection switch cou-
pler securely until a click is heard.
9. Install the fuel filter cover, and then tight-
en the bolts.
10. Install the top cowling.
11. Turn the main switch to the "
sition and check that the water separa-
tor-alert indicator remains off and the
buzzer does not sound. If the water sep-
arator-alert indicator blinks or the buzzer
sounds, have your Yamaha dealer
check the outboard motor. NOTICE: Al-
though the buzzer will stop when the
engine is started and the remote con-
trol lever is moved to the forward or
reverse position, do not use the out-
board motor. Otherwise, serious en-
gine damage could occur.
EMU41261
Treatment of submerged
outboard motor
If the outboard motor is submerged, immedi-
ately take it to a Yamaha dealer. Otherwise
some corrosion may begin almost immedi-
ately. NOTICE: Do not attempt to run the
ZMU07522
" (on) po-
[ECM02391]