Stop Switches; Shifting - Yamaha VF200 Owner's Manual

EMU40461

Stop switches

Perform the following procedure to check
that the main switch and engine shut-off
switch operate properly.
Check that the engine stops when the

main switch is turned to the "
sition.
Check that the engine stops when the clip

is pulled from the engine shut-off switch.
Check that the engine cannot be started

with the clip removed from the engine
shut-off switch.
EMU31734

Shifting

EWM00181
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01611
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
1. Pull the neutral interlock trigger up (if
equipped).
" (off) po-
1. Neutral interlock trigger
2. Move the remote control lever firmly and
crisply forward (for forward gear) or rear-
ward (for reverse gear) about 35 (a de-
tent can be felt).
To shift from in gear (forward/reverse) to
neutral
1. Close the throttle so that the engine
slows to idle speed.
Operation
N
35˚
35˚
F
N
35˚ 35˚
F
1
ZMU07042
R
ZMU07035
R
ZMU06930
61