Q. Are outboard motor mounting bolts loose?
A. Tighten bolts or have serviced by a
Yamaha dealer.
Q. Is steering pivot loose or damaged?
A. Have serviced by a Yamaha dealer.
EMU29434
Temporary action in
emergency
EMU29442
Impact damage
EWM00871
WARNING
The outboard motor can be seriously
damaged by a collision while operating or
trailering. Damage could make the out-
board motor unsafe to operate.
If the outboard motor hits an object in the wa-
ter, follow the procedure below.
1.
Stop the engine immediately.
2.
Check the control system and all compo-
nents for damage. Also, check the boat
for damage.
3.
Whether damage is found or not, return
to the nearest harbor slowly and careful-
ly.
4.
Have a Yamaha dealer check the out-
board motor before operating it again.
EMU46602
Replacing fuse
EWM00632
WARNING
Substituting an incorrect fuse or a piece
of wire could allow excessive current
flow. This could cause electric system
damage and a fire hazard.
If a fuse has blown, replace the fuse accord-
ing to the following procedure.
1.
Turn the main switch to the "
position.
2.
Remove the fuse box cover.
3.
Remove the fuse with a fuse puller, and
then replace it with a spare one of the
proper amperage.
1
ZMU06999
8
1. Fuse box cover
2. Ignition coil / Fuel injector / Variable cam-
shaft timing / ECM (Electronic Control Module)
fuse (30 A)
3. Starter relay fuse (30 A)
4. Fuel pump fuse (15 A)
Trouble Recovery
7
6
5
4
3
2
60
" (off)
ZMU08318
101