Power Trim And Tilt Unit Will Not Operate; Water Separator-Alert Indicator Blinks While Cruising - Yamaha LF225 Owner's Manual

Hide thumbs Also See for LF225:
Table of Contents

Advertisement

fuse using the fuse puller. Install a spare
fuse of the proper amperage.
1
1. Fuse puller
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU40983
Power trim and tilt unit will not
operate
EWM02331
WARNING
Never get under the engine while it is tilt-
ed. Severe injury could occur if the out-
board motor accidentally falls.
If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure
with the power trim and tilt unit, the outboard
motor can be tilted manually.
1.
Stop the engine.
2.
Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1. Manual valve screw
ZMU04337
3.
Tilt the outboard motor up manually to
the desired position, and then tighten the
manual valve screw by turning it clock-
wise.
EMU41891
Water separator-alert indicator blinks
while cruising
EWM02543
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
Do not perform this procedure on a hot
or running engine. Allow the engine to
cool.
There will be fuel in the fuel filter. Keep
away from sparks, cigarettes, flames or
other sources of ignition.
Some fuel will spill during this proce-
dure. Catch the fuel in a rag. Wipe up
any spilled fuel immediately.
The fuel filter must be reassembled
carefully with the O-ring and filter cup
in place. Improper assembly or replace-
ment could result in a fuel leak, which
could result in a fire or explosion haz-
ard.
If the water separator-alert indicator blinks,
perform the following procedure.
1.
Stop the engine.
Trouble Recovery
1
ZMU07196
106

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

F225F250Lf250F300Lf300F250d1 ... Show all

Table of Contents