Subaru Impreza 2016 Manual page 537

7. Tighten the upper and lower screws.
! XV models
1. Using a Phillips screwdriver, remove
the upper and lower screws that secure
the rear combination light assembly.
2. Slide the rear combination light as-
sembly rearward and remove it from the
vehicle.
1) Tail light
2) Backup light
3) Rear turn signal light
3. Remove the bulb socket from the rear
combination light assembly by turning it
counterclockwise.
NOTE
For XV models, the brake lights are the
LED (Light Emitting Diode) type. We
recommend that you consult your
SUBARU dealer for replacement.
4. Pull the bulb out of the bulb socket and
replace it with a new one.
5. Set the bulb socket into the rear
Maintenance and service/Replacing bulbs
combination light assembly and turn it
clockwise until it locks.
1) Guide pins
2) Clip
6. Put the rear combination light assem-
bly into place while aligning the 2 guide
pins and a catch with the guide holes and
a clip on the vehicle.
11-57
– CONTINUED –