Unlocking; Remote Keyless Entry System - Subaru Impreza 2016 Manual

2-20
Keys and doors/Remote keyless entry system
the registered PIN code will be deleted.
You cannot unlock the doors by PIN
Code Access until a new code is
registered.
. After registering a new PIN code,
make sure that you can unlock the
doors using the PIN code.
. The PIN code cannot be deleted
while the keyless access function is
disabled by operating the access key.
. Reregister the PIN code in the
following case.
– when you forget the PIN code
– when you want to change the PIN
code
& Unlocking
Perform steps 1 to 5 described in Regis-
tration .
NOTE
. You cannot unlock by PIN Code
Access in the following cases.
– when the access key is within the
operating ranges
– when the ignition switch is in the
"ACC" or "ON" position
. If you make an operation error
during the unlocking procedure, start
over with the unlocking procedure after
waiting for 5 seconds or longer.
. To protect your vehicle from theft, a
buzzer will sound if incorrect PIN codes
are entered five times continuously. If
this occurs, you cannot unlock the
doors by PIN Code Access for 5
minutes.

Remote keyless entry system

The remote transmitter can be used within
a distance of approximately 1.0 m (3.2 ft)
of the vehicle. It can be used for the
following purposes:
. to lock or unlock all of the doors
. to lock or unlock the rear gate (5-door)
. to open the trunk lid (4-door)
The system s operable distance will be
shorter in areas near a facility or electronic
equipment emitting strong radio waves
such as a power plant, broadcast station,
TV tower, or remote controller of home
electronic appliances.
CAUTION
. When you carry the remote trans-
mitter on an airplane, do not
press the button of the remote
transmitter while in the airplane.
When any button of the remote
transmitter is pressed, radio
waves are sent and may affect
the operation of the airplane.
When you carry the remote trans-
mitter in a bag on an airplane,
take measures to prevent the
buttons of the remote transmitter
from being pressed.