Immobilizer Indicator Light; Shift-Up Indicator Light (Mt Models Without Gear Shift Indicator) - Subaru Impreza 2016 Manual

3-34
Instruments and controls/Warning and indicator lights
&
Immobilizer indicator
light
This light begins flashing under any of the
following conditions.
For models with "keyless access with
push-button start system":
. Immediately after the push-button igni-
tion switch is turned to the OFF position.
. Immediately after the driver s door is
opened or closed when all of the following
conditions are met.
The push-button ignition switch is in
the ON or ACC position.
The access key is outside the
vehicle.
The engine is not running.
In the event that the push-button ignition
switch is pressed to turn it on or to start
the engine carrying an unauthorized key
(for example, the key is unregistered or
the ID code does not match), the power is
not switched to ON and the immobilizer
indicator light continues blinking.
For models without "keyless access
with push-button start system":
. Approximately 60 seconds after the
ignition switch is turned from the ON
position to the ACC or LOCK position.
. Immediately after the key is pulled out.
If the indicator light does not blink in the
above conditions, it may indicate that
immobilizer system may be malfunction-
ing. We recommend that you contact your
nearest SUBARU dealer immediately.
In the event that an unauthorized key (for
example, an unauthorized duplicate) is
used to start the engine, the immobilizer
indicator light illuminates. For details
about the immobilizer system, refer to
Immobilizer F2-2.
NOTE
Even if the immobilizer indicator light
flashes irregularly or its fuse blows (the
light does not flash if its fuse is blown),
the immobilizer system will function
normally.
&
Shift-up indicator light
(MT models without gear
shift indicator)
While driving, this indicator light illumi-
nates and informs the driver about the
upshift timing for fuel-efficient driving.
The shift-up indicator can be activated or
deactivated by performing the following
procedure.
1. Turn the ignition switch to the LOCK /
OFF or ACC position.
2. Press the trip knob to show
on the trip meter display.
The display can be switched as shown in
the following sequence by pressing the
trip knob.
or