Clutch Fluid (Mt Models); Checking The Fluid Level; Brake Booster - Subaru Impreza 2016 Manual

Clutch fluid (MT models)

& Checking the fluid level
1) MAX level line
2) MIN level line
3) The fluid level must be checked in this
area.
Check the fluid level monthly.
Check the fluid level on the outside of the
reservoir. Because this reservoir is used
for both the brake and clutch systems and
has chambers for each system, be sure to
check the fluid level for the clutch system
at the inboard side of the reservoir
(shaded area in the illustration). If the level
is below MIN , add the recommended
brake fluid (clutch fluid) to MAX .
Use only brake fluid (clutch fluid) from a
sealed container.
NOTE
The fluid level for the clutch system
must be checked at the inboard side of
the reservoir. It cannot be checked at
the outboard side of the reservoir.
Maintenance and service/Clutch fluid (MT models)

Brake booster

If the brake booster does not operate as
described in the following, we recommend
that you have it checked by your SUBARU
dealer.
1. With the engine off, depress the brake
pedal several times, applying the same
pedal force each time. The distance the
pedal travels should not vary.
2. With the brake pedal depressed, start
the engine. The pedal should move
slightly down to the floor.
3. With the brake pedal depressed, stop
the engine and keep the pedal depressed
for 30 seconds. The pedal height should
not change.
4. Start the engine again and run for
approximately 1 minute then turn it off.
Depress the brake pedal several times to
check the brake booster. The brake
booster operates properly if the pedal
stroke decreases with each depression.
11-29