Daytime Running Light System (If Equipped); Turn Signal Lever; One-Touch Lane Changer - Subaru Impreza 2016 Manual

& Daytime running light system
(if equipped)
WARNING
The light switch must always be
turned to the " " position when it
is dark outside.
The daytime running light will automati-
cally illuminate at reduced brightness
when the following conditions are fulfilled.
. The engine is running.
. The light control switch is in the
AUTO (if equipped) or off position.
NOTE
. If the parking brake is applied when
you start the engine, the daytime run-
ning light will illuminate when the
parking brake is released.
. When the headlight switch is in the
" " or " " position, the daytime
running light system is deactivated.
. For models with the auto on/off
headlights, while the headlight switch
is in the "AUTO" position and the
headlights turn on automatically, the
daytime running light is deactivated.

Turn signal lever

Turn signal lever
To activate the right turn signal, turn the
lever clockwise. To activate the left turn
signal, turn the lever counterclockwise.
When the turn is finished, the lever will
return automatically. If the lever does not
return after cornering, return the lever to
the neutral position by hand.
To signal a lane change, push the turn
signal lever clockwise or counterclockwise
slightly and hold it during the lane change.
The turn signal indicator lights will flash in
the direction of the turn or lane change.
The lever will return automatically to the
neutral position when you release it.
Instruments and controls/Turn signal lever
& One-touch lane changer
To flash the turn signal and turn signal
indicator light three times, push the turn
signal lever clockwise or counterclockwise
slightly and immediately release it.
The operational/non-operational setting of
the one-touch lane changer s can be
changed by a SUBARU dealer. Contact
the nearest SUBARU dealer for details.
3-99