7_3_2 iSC350 Power Requirements
The iSC350 can receive power from the POS system or via an external power supply provided by Ingenico. When interfacing to the
POS via RS-232, USB (5V), or Ethernet interfaces, a separate Ingenico power supply (192008227) is required. Power may also be
provided by the POS via USB (12V or 24V) or RS-485 (via Multipoint) connections. If an Ingenico power supply was provided with
the terminal, plug the power supply connector into the jack on the Multipoint cable.
Connect the cable to the Multipoint port before connecting power to the terminal. Only use the power supply which was
provided by Ingenico.
Do not disconnect power from the terminal until you have been instructed to do so.
Before you disconnect the terminal from the POS, you must first disconnect power in order to prevent damage to the
terminal.
7_3_3 iSC350 Secure Access Modules
There are three optional Secure Access Module (SAM) slots for the iSC350 which are accessible via an access door located on the
bottom of the terminal as shown in the below image.
42/57 Telium Troubleshooting Guide / June 28, 2014