Related Manuals for Ingenico iPP350
Summary of Contents for Ingenico iPP350
- Page 1 Ingenico iPP350 Cable Swap Doc Ref: iPP350CSP Ingenico iPP350 New Generation Cable Swap Procedure STATUS: Issued Date Created: 23/02/2011 Author: James Christou Owner / Authority: Nigel Davis Doc Reference: iPP350CSP Version 1.0 (Issued) Page 1 of 5...
- Page 2 Ingenico iPP350 Cable Swap Doc Ref: iPP350CSP Introduction Please follow these instructions to replace the Ingenico iPP350 card reader cable to the new generation cable; total upgrade time per unit is approximately 2 minutes. Important Make sure that you have disconnected the power cord from com port 5 under the unit before you start.
- Page 3 Ingenico iPP350 Cable Swap Doc Ref: iPP350CSP 5. Remove the two screws to release the cable security cover Keep the 2 screws for re fixing once the new cable is in place 6. Lift and Remove the cable security cover After removing discard cable module cover 7.
- Page 4 Ingenico iPP350 Cable Swap Doc Ref: iPP350CSP 8. Remove new generation cable from bag ready for installation 9. Insert the new generation cable 10. Push down completely and lock down the hinged handle and screw in the 2 small screws to make the cable more secure...
- Page 5 Ingenico iPP350 Cable Swap Doc Ref: iPP350CSP 12. Please reconnect the card reader cable under the POS (Till) unit back in to com port 13. Once connected the card reader should power back on 14. Finish Version 1.0 (Issued) Page 5 of 5...