IBM TotalStorage SAN256N Director 2045-N16 Installation And Maintenance Manual page 104

9. After about 90 seconds you will see the following message:
10. This will take you back to the General tab display.
11. Click OK to return to the Navigation Tree Menu.
12. Verify that the applicable board has been taken offline in the Boards display.
13. You should also check that the Online LED on the TFIO board is not lit. A final place
14. Remove all connected data cables from ports on the TFIO card and label each
15. Install dust covers in TFIO board port connectors where fiber optic cables have
16. Loosen the spring-loaded captive screws from the top and bottom TFIO card ejector
17. Using the card ejector latches, pull and slide the board out from the SAN256N
18. Place the removed TFIO in a plastic antistatic bag.
Installing a TFIO blade
1. Remove the new TFIO blade from the plastic antistatic bag.
2. Refer to the front and rear chassis views as a reference on where the TFIO blades
3. Carefully push and slide the module into the SAN256N chassis until firmly seated
4. Push and lock card ejector tabs closed to secure the TFIO blade into position in
5. On the Enterprise Manager Client select the Boards tab then right click the
6. Scroll over to the Valid column on the far right to confirm that the code is valid.
7. To Online the board right click the appropriate board then select Configuration from
84
SAN256N Director 2045-N16
The changes were applied successfully
[OK]
you can check the status is on the 8 character display on the TCM Module. You
should see the following:
[OFLN]IOnn (nn is the IO slot number)
cable as they are removed.
been removed.
latches. Grasp both card ejector latches and pull the latch tabs forward to unlatch
the board.
director chassis slot guides.
A TFIO blank panel air baffle must be installed in any TFIO
Attention:
chassis slot if the removed board is not being replaced, otherwise damage to
equipment may result.
are located on the SAN256N director.
against backplane connector.
SAN256N chassis. Secure the board by tightening the spring loaded screws in the
top and bottom card ejector latches.
previously inserted board. Select Versions from the drop down menu.
Note: If the Flash version and Firmware Version do not match, perform a code load
from the Code Load button on the toolbar.
the drop down menu.