Installing And Setting Up Enterprise Manager 9.X On An Existing Fc/9000 Platform - IBM TotalStorage SAN256N Director 2045-N16 Installation And Maintenance Manual

Note: If you purchased an Eneterprise Manager workstation from IBM, the software will
Installing and setting up Enterprise Manager 9.x on an existing FC/9000
platform
This section describes the steps to upgrade an existing Enterprise Manager workstation
from Enterprise Manager version 8.3.x to version 9.x to allow operation of the SAN256N
director within the FC/9000 fabric.
Note: Enterprise Manager versions earlier than 8.3.x are not supported.
The primary requirements for SAN256N director and FC/9000 operation are:
• Enterprise Manager version 9.x
• SAN256N director system operating version 1.x firmware
• FC/9000 system operating version 5.x firmware
Install Java Runtime Environment (JRE) Software
Use this procedure to install the Java Runtime Software.
Note: IBM recommends that previous versions of Java and Java Webstart are
1. Insert the Enterprise Manager version 9.x CD into the CD drive of the workstation.
2. Run j2re1-4-2-04-windows-i586-p.exe from the Enterprise Manager CD to install
3. Run the Java installation wizard and accept all default settings. After the program
Installing Enterprise Manager 9.x software
Use this procedure to install version 9.x of the Enterprise Manager.
1. Run Setup.exe from the Enterprise Manager CD.
2. Click Yes to the configuration snapshot question.
3. Click Next at the Enterprise Manager installation startup screen.
4. Select I Agree, then click Next on the License Agreement screen.
5. Click Next to accept English on the Local Language screen.
6. Accept the default directory for the Enterprise Manager installation, click Next.
Note: In an Enterprise Manager upgrade installation, all configuration database files
7. Click Next on the Enterprise Manager Installation Location screen to start the
be installed on the PC. Refer to the IBM TotalStorage SAN n-type Director Family
Enterprise Manager Installation and Operator Guide (GC26-7720) for more
information.
uninstalled prior to the installation of the Java Software.
Open Windows Explorer and select the CD drive.
the Java software. Click Yes on the ConfigSave screen to save the existing
configuration. Java creates a file of the current configuration.
loads, click Finish to exit the installation wizard. Perform a restart of the workstation
to complete the Java installation.
are already established in this directory path. IBM does not recommend selecting
a new directory path with existing database files.
installation.
Chapter 3. Installation
49