Trace Route Test Result; Trace Route Test Configuration; Device Tests - VBrick Systems 7000 Series Admin Manual

Network video appliances
Table of Contents

Advertisement

Trace Route Test Result

The results of the test appear at the top of the screen. The results include the
of the Destination Host Name. When the test is finished or stopped, the
Address
will display the result of the test, such as "Test Done," or "Max hops (=30) Finished,"
Result
or "Test Stopped," etc. An entry shows the hop number, which is equal to the TTL, IP
address (and Host Name if available) of the gateway, and round trip time of each probe. If the
probe answers are received from different gateways, the address of each responding system
will be shown. If there is no response within a 5 second timeout interval, a "*" is printed for
that probe. If the result string exceeds 255 characters, the string will be terminated by ending
it with "Too Long."
Resolved IP Address IP Address of destination.
Traceroute Result
Summary

Trace Route Test Configuration

Destination
Probe Count

Device Tests

The H.264 appliance automatically performs a full POST (Power On Self Test) hardware test
whenever the unit is powered-on or reset. The Device Test runs the POST and displays the
results. The
Operational Mode
to run this test. When done, be sure to reset the appliance to Run mode or you
Diagnostics
will not be able to stream video.
To run the Device Test
1. Go to System Configuration > General and set the
2. Go back to the Device Tests page and click
3. Set the test parameters (see below).
4. Click
and wait a few seconds to see the test results.
Start
5. When done go back to System Configuration > General and set the
.
Run
VBrick H.264 Appliance Admin Guide
Displays "done" when finished.
Shows results summary including byte packet size and number of
hops.
Select Host Name or unicast IP Address (multicast IP Addresses are
not valid).
Can be set from 3 to 20. The default setting is 3. This setting is the
number of probe packets sent to a host at each hop.
(on the System Configuration > General page) must be set to
Operational Mode
.
Edit
Operational Mode
Troubleshoot
Resolved IP
Overall
to
.
Diagnostics
to
71

Advertisement

Table of Contents
loading

Related Products for VBrick Systems 7000 Series

Table of Contents