Video Template Settings - VBrick Systems 7000 Series Admin Manual

Contrast Boost
Enhancer
Edge Enhancer
Horizontal
Frequency Boost
Brightness
Contrast
Saturation
Tint
Blackout Bottom
(Top, Left, Right)

Video Template Settings

The lower area of the Video page has a set of parameters that can be controlled by pre-
configured templates. Use the
with pre-configured video values (or select
selected
Video Format
bandwidth. 750k High Motion is the default template. All video encoder parameters defaults will
match these values.
Table 4. Video Template Settings †
Template Best
Quality
Bit Rate 8M
Resolution
1080/720 16:9 1280x720 960x544
NTSC/480 16:9 656x368
PAL/576 16:9 656x368
NTSC/480 4:3 640x480
PAL/576 4:3 640x480
VBrick H.264 Appliance Admin Guide
Default = Disabled. Supplements existing Contrast setting. Check to
enable.
Default = Disabled. Sharpens edges in active video region for both
Luma and Chroma. Set to Low, Med, or High.
Default = Disabled. Amplifies the appropriate video frequency band.
• Med – amplifies the middle frequency band of the displayed video.
• High – amplifies the highest frequencies of the displayed video.
• Med & High – amplifies the highest and middle frequencies of the
displayed video.
0–100. Default = 50. Brightness is information about the varying light
intensity of an image which is best described as brightness.
0–100. Default = 50. The contrast is the range of light-to-dark values
of an image that are proportional to the voltage differences between
the black and white levels of the signal.
0–127. Default = 64. Saturation is the spectral intensity of a color. It
operates on the PbPr chroma components of the color space by
increasing or decreasing both components by the same percentage.
-50–50 degrees. Default = 0. The tint is the attribute by which a color
may be identified within the visible spectrum. Tint refers to the
spectral colors of red, orange, yellow, green blue and violet. Note:
Adding Tint reduces the saturation.
0–10. Default = 0. Some files include additional information that
results in undesirable artifacts on some sides of the video frame. This
option blacks out an area around the player window—not a specific
number of lines. (Top, Left, and Right are only available with HD
inputs.) Be sure to test your results when using this option.
Load Template
and
Video Aspect Ratio
4M Very High 1.5M High 750k High
Quality Quality Motion ††
4M 1.5M 750k
960x544 656x368
656x368 656x368 656x368
656x368 656x368 656x368
640x480 640x480 400x304
640x480 640x480 400x304
button to populate the Video Template Settings
). The video settings vary depending on the
None
. Choose a template based on motion and
500k Low 128k High
Motion Motion
500k 128k
Resolution
656x368 256x144
656x368 256x144
656x368 256x144
640x480 320x240
640x480 320x240
Video/Audio Configuration
128k Low Security &
Motion Surveillance
128k 300k
256x144 656x368
256x144 656x368
256x144 656x368
400x304 640x480
400x304 640x480
35