Table of Contents
Advertisement
Figure 9. Transmitters: Part 2 – Advanced Settings
Announce
Use Global Announce IP and Port
Send to Unicast Destination
Destination IP Address
Port
External Announce Settings
These settings configure an external announcement that can be used when the stream is
reflected to a third-party server or a (future) VBrick reflector.
52
This section is used to announce the RTSP streams to
the local network allowing viewable RTSP
announcements in programs like StreamPlayer. The
unit must be on the same segment of the network or
the router must be configured to retransmit broadcast
packets for the announcements to be accessible using
the IP address 255.255.255.255.
Use Announce IP Address for Transmitters and
Announce Port defined on Program Configuration >
Global page. If checked, the Destination and Port
fields are greyed out.
If enabled and the destination is unicast, the unicast
IP address is used for the announcement and the
Destination field is greyed out. Default = Disabled.
The destination IP Address or Host Name the
announcement is sent to. By default, the
announcement is sent to the multicast network. If
using an EtherneTV Portal Server, enter the Portal Server
IP address.
The destination port the announcement is sent to.
© 2009 VBrick Systems, Inc.
Advertisement
Table of Contents
