Table of Contents
Advertisement
DTR Control
COM Interface Type
Operational State
SNMPv3 Passwords
Use this page to manage SNMP passwords. The same fields are used to define passwords for
all users.
User Name
Authentication Password Enter password. Cannot exceed 20 characters. May include any
Authentication Protocol
Privacy Password
Security Level
VBrick H.264 Appliance Admin Guide
Force OFF, Force ON or Automatic. If automatic, the control will
be ON when Passthrough is active. See note above.
Describes the COM interface connector.
• RS232 – standard RS-232 serial port connector.
• RS422/485 – RS-422/485 4-wire serial port connector.
Describes the current status of a Passthrough connection,
including error conditions, if any. Refer to the Monitor > Network
page. This will display "Active" if in Passthrough mode.
Read-only. Set user name on Usernames & Passwords page.
combination of alphanumeric characters but only the following
special characters:
~ ! # $ ^ * + & [ ] { } | < >
defaults.
Select protocol: HMAC-MD5 or HMAC-SHA.
Required.
No Authentication, No Privacy (Default).
Authentication. No Privacy.
Authentication and Privacy (CBC-DES)
System Configuration
See Table 2 for
29
Advertisement
Table of Contents
