Transmitter Name
Destination IP
State
Bytes Transferred
IP Packets Sent
Servers
This page shows the program status for all servers. Use the dropdown list box to select a
specific server.
Note When CPU usage on the selected server is extremely high, auto-refresh is disabled but
you can still use the
VBrick H.264 Appliance Admin Guide
Transmitter name from Program Configuration > Transmitter page.
Destination IP Address or Host Name from Program Configuration >
Transmitter page.
• Transmitting – no transmitter problems detected.
• Disabled – transmitter has not been enabled.
• Ping Failed – ping to unicast destination failed.
• Ports Not Open – IP port failure.
• Loopback Address – destination address is a loopback address.
Use Reset Counters to reset to zero.
Use Reset Counters to reset to zero.
button to manually refresh the page.
Refresh
Monitor
65