Table of Contents
Advertisement
Operational State
Passthrough State: Initiator
Passthrough State
Destination
Dedicated Destination The VBrick appliance (whose serial port is the destination of this
Dedicated Port
Baud Rate
Stop Bits
Parity
RTS Control
28
Describes the current status of a Passthrough connection, including
error conditions, if any. Refer to the Monitor > Network page. This
will display "Active" if in Passthrough mode.
Initiator – In this case it will continuously attempt to automatically
initiate a Passthrough connection to the remote destination. This
mode also offers metadata destination options.
Read-only: Dedicated.
COM port) can be configured and identified using either an IP
address or a host name.
Default - 4439.
Rate of Passthrough port. Rate can be set to the following (Default
= 9600): 110, 300, 600, 1200, 2400, 3600, 4800, 7200, 9600, 14400,
19200, 28800, 38400, 57600, 115200.
Number of stop bits for Passthrough port (1 or 2).
None, Even, Odd.
Force OFF, Force ON or Automatic. If automatic, the control will
be on when Passthrough is active.
Note: DTR and RTS are not available for COM. Under no
conditions are RTS or DTR controls passed through end-to-end.
All control handling is local.
© 2009 VBrick Systems, Inc.
Advertisement
Table of Contents
