Usb Board - HP OMEN 15-ek0000 Maintenance And Service Manual

NOTE: Use the same steps to remove each fan.
1. Disconnect the fan cable from the system board (1).
2. Remove the three Phillips M2.0 × 5.0 screws (2) that secure the fan to the computer.
3. Remove the fan from the computer (3).
Reverse this procedure to install the fans.

USB board

To remove the USB board, use this procedure and illustration.
Table 6-8 USB board description and part number
Description
USB board
USB board cable
Before removing the USB board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the solid-state drives
4. Remove the battery (see
5. Remove the heat sink (see
6. Remove the right fan (see
Remove the USB board:
46 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page 31).
(Solid-state drive on page
Battery on page 37).
Heat sink on page 42).
Fans on page 45).
31).
32).
Spare part number
L98742-001
L98725-001