HP OMEN 15-ek0000 Maintenance And Service Manual page 43

Table 5-2 Solid-state drive descriptions and part numbers
Description
1 TB, PCIe, TLC
512 GB, PCIe, TLC
512 GB solid-state drive + 32 GB Optane memory module
256 GB, PCIe, TLC
Solid-state drive thermal pad
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board
Remove the solid-state drive:
NOTE: Use the same procedure to remove both solid-state drives.
1. Remove the Phillips M2.0 × 5.0 screw that secures the drive to the computer (1).
2. Lift the drive to a 45° angle (2), and then remove the cover from the drive (3).
3. Pull the drive away to remove it from the socket (4).
To install the solid-state drive, reverse the removal procedures.
When installing a new solid-state drive, be sure to install the thermal pad to the inside of the cover.
(Preparation for disassembly on page
(Bottom cover on page 31).
(Battery on page 37).
Component replacement procedures
Spare part number
L85348-001
L85360-001
L85366-001
L85350-001
L98956-001
31).
33