Power Connector Cable - HP OMEN 15-ek0000 Maintenance And Service Manual

Before removing the RGB board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the solid-state drive to the left of the battery
4. Remove the battery (see
Remove the RGB board:
1. Disconnect the four cables from the ZIF connectors on the RGB board (1)–(4).
2. Remove the two Phillips M2.0 × 4.0 screws (5) that secure the board to the computer.
3. Remove the RGB board from the computer (6).
Reverse this procedure to install the RGB keyboard control board.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 6-3 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
(Preparation for disassembly on page
(Bottom cover on page
Battery on page 37).
(Preparation for disassembly on page
(Bottom cover on page
31).
(Solid-state drive on page
31).
Component replacement procedures
31).
32).
Spare part number
L98734-001
31).
39