Rj-45 Door - HP OMEN 15-ek0000 Maintenance And Service Manual

1. Disconnect the cable from the system board ZIF connector (1).
2. Lift the cable to release it from the computer (2).
3. Remove the board from the computer (3).
Reverse this procedure to install the USB board.

RJ-45 door

To remove the RJ-45 door, use this procedure and illustration.
Table 6-9 RJ-45 door description and part number
Description
RJ-45 door for use in models with GeForce GTX 1660, 1660Ti, and RTX graphics cards
RJ-45 door for use in models with GeForce GTX 1650, 1650Ti graphics cards
Before removing the RJ-45 door, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
Remove the RJ-45 door:
1. Use a flat tool to push the tab on the inside-bottom of the door toward the outside of the system board
to release it (1).
(Preparation for disassembly on page
(Bottom cover on page 31).
Spare part number
L98959-001
L99533-001
31).
Component replacement procedures 47