CDVI DIGIWAY PLUS Instructions For Installation, Use And Maintenance Manual page 28

INSTALLATION MANUAL
DIGIWAY PLUS
The range of motors for the double door is described in the following table:
Double door total width
1600 mm
1700 mm
1800 mm
1900 mm
2000 mm
With the motors DWPD, with central profile, the product comes already equipped with synchronization cable.
It is also possible to use 2 single door units ( DWP102x) to automate a double leaf door with synchronization of each leaf.
For that use the serial cable DWPCS ( optional ).
The cable is terminated with 2 special 3-way connectors and must be inserted in the corresponding slot located under the logic card of the
unit ( see image below ).
1 ) Connect the motors referring to the electrical diagram of the single door.
WARNING: in the double door mode, with leaves overlapping (rebated), it is very important to identify the type of unit
• MASTER unit drives the leaf which opens first and closes last
• SLAVE unit drives the leaf which opens last and closes first
2 ) Connect the RADARs, the Day/Night switch to the unit identified as MASTER
3 ) The contacts NC of the safety devices ( photocells ) can be connected in 2 ways:
• Connect the photocells contacts to the terminals 5,6,7 of the corresponding unit electronic card
• Put in serial the contacts of all the photocells, connect them to the terminals 5,6,7 of the MASTER unit and make a bridge to the
contacts 5,6,7 of the SLAVE unit.
4 ) Connect the electrolock to the MASTER unit
5 ) On the SLAVE unit memorize only the 4ch remote control needed to navigate in the SLAVE unit menu, on the Master unit memorize the
navigation transmitter and any other transmitter used to open the door
attentIon : Do not memorize the same 4ch navigation transmitter on both the units!
cdvi.com
28
cdvigroup.com
part II: electrical connections
Leaves width p/n Articulated Arm
70 - 80 mm DWPD10216ACD
81 - 85 mm DWPD10217ACD
86 - 90 mm DWPD10218ACD
91 - 95 mm DWPD10219ACD
96 - 100 mm DWPD10220ACD
Serial cable DWPCS
Slave
p/n Sliding Arm
DWPD10216SCD
DWPD10217SCD
DWPD10218SCD
DWPD10219SCD
DWPD10220SCD
3
Master
p/n Universal Arm
DWPD10216UCD
DWPD10217UCD
DWPD10218UCD
DWPD10219UCD
DWPD10220UCD
EN