Install The Riser For Slot 1 To 4 (Riser 1) - Lenovo ThinkAgile VX7820 User Manual

Figure 128. Riser for slot 16 to 17 removal
Step 1. Loosen the captive screw (item 1 in preceding figure) that secures the riser to the I/O tray board.
Step 2. Lift the riser up and out of the I/O tray.
After you remove the riser:
• If you are replacing the riser, remove any adapters installed in the riser. See "Remove an I/O adapter from
slot 16 to 17" on page 97.
• If you are removing the riser and are not installing a replacement:
1. Install the screw that secures the I/O tray board to the I/O tray (item 3 in the figure). This screw
replaces the captive screw on the rear edge of the riser below the midplane connectors. Screw
location is labelled "Remove screw before installing riser" on the I/O board.
2. Install the I/O tray fillers in adapter slot 16 to 17 (item 4 in the figure).
3. Install the I/O tray and connect all cables. See "Install the I/O tray" on page 154.
If you are instructed to return the riser, follow all packaging instructions, and use any packaging materials for
shipping that are supplied to you.

Install the riser for slot 1 to 4 (riser 1)

The riser for adapter slot 1 to 4 (riser 1) is in the I/O tray that is accessed from the rear of the server. After
installing adapters in the riser, insert the riser in the I/O tray and secure it with two captive screws.
S002
User Guide for ThinkAgile VX7820 Appliance, ThinkAgile VX 4-Socket 4U Certified Node
218