Table of Contents
Advertisement
Install the upper tray filler
The upper tray filler is at the front of the server. Insert the upper tray filler in the front of the server and secure
it with four screws.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
S037
CAUTION:
The weight of this part or unit is more than 55 kg (121.2 lb). It takes specially trained persons, a lifting
device, or both to safely lift this part or unit.
S036
18 - 32 kg (39 - 70 lb)
32 - 55 kg (70 - 121 lb)
"
" on page 89 "
" on page 65
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Complete the following steps to install the upper tray filler:
.
Chapter 9
Hardware replacement procedures
239
Advertisement
Table of Contents
