Table of Contents
Advertisement
"
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you remove an adapter from slot 5 to 8:
1. Disconnect and label all cables connected to adapters in the I/O tray; then, remove the I/O tray. See
"Remove the I/O tray" on page 152.
2. Remove the riser for slot 1 to 4 (riser 1) to access the adapter connectors in the I/O tray. See "Remove
the riser for slot 1 to 4 (riser 1)" on page 212.
Complete the following steps to remove an adapter from slot 5 to 8.
Watch the procedure. A video of the installation process is available:
•
YouTube
•
Youku
Figure 44. Adapter removal (slot 5 to 8)
Step 1.
Disengage the adapter from its connector on the I/O tray and lift the adapter from the I/O tray.
After you remove the adapter:
• If you are removing the adapter and are not installing a replacement:
1. Install a filler in the empty adapter slot.
2. Install the riser for slot 1 to 4 (riser 1). See "Install the riser for slot 1 to 4 (riser 1)" on page 218.
3. Install the I/O tray and connect all cables. See "Install the I/O tray" on page 154.
If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.
User Guide for ThinkAgile VX7820 Appliance, ThinkAgile VX 4-Socket 4U Certified Node
94
" on page 89 "
" on page 65
Advertisement
Table of Contents
