Remove A Pcie Adapter From Slot 10 To 15 - Lenovo ThinkAgile VX7820 User Manual

Figure 45. LOM adapter removal (slot 9)
Step 1. Fully loosen the captive thumbscrew on the side of the LOM adapter that secures it to the bracket
on the I/O tray.
Step 2. Disengage the LOM adapter from its connector on the I/O tray and lift the adapter from the I/O tray.
After you remove a LOM adapter:
• If you are removing the adapter and are not installing a replacement:
1. Install a filler in slot 9.
2. Install the riser for slot 10 to 15 (riser 2). See "Install the riser for slot 10 to 15 (riser 2)" on page 220.
3. Install the I/O tray and connect all cables. See "Install the I/O tray" on page 154.
If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.

Remove a PCIe adapter from slot 10 to 15

PCIe adapters in slot 10 to 15 are in an I/O tray riser that is accessed from the rear of the server. After
removing the I/O tray and the riser for slot 10 to 15 (riser 2), open the retention latch and remove the adapter
from the riser.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
User Guide for ThinkAgile VX7820 Appliance, ThinkAgile VX 4-Socket 4U Certified Node
96