Table of Contents
Advertisement
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts). The default value is
PASSW0RD (with a zero 0 not an O).
Note: BMC, IMM, or XCC internal LAN/USB IP address, account name, and password are
all valid for this command.
Examples that do use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model> --host <xcc_ip>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n> --host <xcc_ip>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag> --host <xcc_ip>
Step 2.
Reset IMM to the factory defaults. Go to
com.lenovo.systems.management.xcc.doc/NN1ia_c_resettingthexcc.html
Step 3.
Reset the Lenovo XClarity Controller to the factory defaults. Go to
help/topic/com.lenovo.systems.management.xcc.doc/NN1ia_c_resettingthexcc.html
information.
Enable TPM/TCM
The server supports Trusted Platform Module (TPM), Version 1.2 or Version 2.0
Note: For customers in Chinese Mainland, TPM is not supported. However, customers in Chinese Mainland
can install a Trusted Cryptographic Module (TCM) adapter (sometimes called a daughter card).
When a system board is replaced, you must make sure that the TPM/TCM policy is set correctly.
CAUTION:
Take special care when setting the TPM/TCM policy. If it is not set correctly, the system board can
become unusable.
Set the TPM/TCM policy
By default, a replacement system board is shipped with the TPM/TCM policy set to undefined. You must
modify this setting to match the setting that was in place for the system board that is being replaced.
You can set the TPM/TCM policy from Lenovo XClarity Provisioning Manager.
Complete the following steps to set the TPM/TCM policy.
Step 1.
Start the server and when prompted, press F1 to display Lenovo XClarity Provisioning Manager
Lite.
Step 2.
If the power-on Administrator password is required, enter the password.
Step 3.
From the System Summary page, click Update VPD.
Step 4.
Set the policy to one of the following settings.
• TCM enabled - Chinese Mainland only. Customers in Chinese Mainland should choose this
setting if a TCM adapter is installed.
• NationZ TPM 2.0 enabled - Chinese Mainland only. Customers in Chinese Mainland should
choose this setting if a NationZ TPM 2.0 adapter is installed.
• TPM enabled - ROW. Customers outside of Chinese Mainland should choose this setting.
• Permanently disabled. Customers in Chinese Mainland should use this setting if no TCM
adapter is installed
Although the setting undefined is available as a policy setting, it should not be used.
https://sysmgt.lenovofiles.com/help/topic/
.
Chapter 9
for more information.
https://sysmgt.lenovofiles.com/
for more
Hardware replacement procedures
159
Advertisement
Table of Contents
