Table of Contents
Advertisement
"
Attention: Do not use the riser for slot 16 to 17 with four socket storage rich configurations.
Before you install the riser for slot 16 to 17:
1. Make sure that there is no screw (item 2 in following figure) securing the I/O tray board to the I/O tray in a
location where a captive riser screw will be installed.
2. Make sure that there are no I/O tray fillers installed in adapter slot 16 to 17.
3. Install adapters in the riser. See "Install an I/O adapter in slot 16 to 17" on page 104.
4. If any of the adapters in the riser have internal cables, make sure that they are connected before
installing the riser in the I/O tray.
Complete the following steps to install the riser for slot 16 to 17.
Watch the procedure. A video of the installation process is available:
•
YouTube
•
Youku
Figure 132. Riser for slot 16 to 17 installation
Step 1.
Align the riser with the I/O tray, making sure that the sides of the riser fit into the guides on the I/O
tray, and insert the riser; then, press the riser into the I/O tray until the connector is fully seated.
Step 2.
Tighten the captive screw (item 4 in preceding figure) that secures the riser to the I/O tray board.
If you have no other operations to perform on the I/O tray after installing the riser for slot 16 to 17, install the I/
O tray in the chassis and connect all cables. See "Install the I/O tray" on page 154.
" on page 89 "
" on page 65
.
Chapter 9
Hardware replacement procedures
223
Advertisement
Table of Contents
