Husqvarna Rider 213C Workshop Manual page 48

8. Pull the main belt from the engine pulley and put it to
the side.
9. Pull the transmission belt off the engine pulley and
move it below the engine belt pulley.
10. Pull out the transmission belt through the opening
below the pivot bearing and past the belt tensioner.
9.9.4 To install the transmission belt
1. Pull the transmission belt through the opening below
the pivot bearing and past the belt tensioner pulley.
2. Pull the transmission belt below the engine belt
pulley and put it on the engine belt pulley.
3. Put the transmission belt on the hydrostatic
transmission pulley.
4. Attach the cooling fan.
5. Do a check that the main belt is installed correctly on
the front pulley.
48 - Repair instructions
6. Attach the main belt on the engine pulley.
7. Attach the belt guide for the main belt.
8. Attach the spring.
9.9.5 To remove and attach the main belt
1. Remove the rear belt guide for the main belt.
2. Remove the main belt and attach a new belt.
3. Assemble and adjust the belt guide to the lower belt
in the engine belt pulley.
420 - 002 - 22.03.2018