Husqvarna Rider 213C Workshop Manual page 19

different wheels. Do not mix parts from different
wheels.
1. Put supports below the product.
2. Remove the protective cap.
3. Remove the circlip.
4. Pull off the wheel from the axle.
5. Collect the key, spacer sleeve and washers from the
axle.
6. Assemble in opposite sequence.
420 - 002 - 22.03.2018
9.1.6 Rear axle
9.1.6.1 To disassemble the pivoting rear axle
1. Put supports below the product in front of the
articulated steering.
2. Make marks on the hydraulic hoses to make it easier
to connect them correctly when the pivoting rear
axle is assembled.
3. Disconnect the hydraulic hoses from the couplings
below the product.
4. Remove the idler spring.
5. Remove the hydrostatic transmission cable from the
arm and the casing from the ball joint.
Repair instructions - 19