Husqvarna Rider 213C Workshop Manual page 40

To keep the hydraulic system
Obey the instructions in
clean on page 30 .
1. Put a container below the drain plugs.
2. Open the 2 plugs to drain the front hydrostatic
transmission.
3. Open the 2 plugs to drain the rear hydrostatic
transmission.
4. Replace the hydrostatic transmission filter. See
replace the hydrostatic transmission filter on page
40 .
5. Attach the drain plugs.
6. Fill the transmission oil tank with oil.
7. Bleed the hydrostatic transmission. See
the drive system on page 31 .
8. Do a test of the product and fill with oil to the correct
level in the transmission oil tank.
9.5.12.3 To replace the hydrostatic transmission filter
WARNING: Transmission oil is dangerous to
your skin. Clean spills with soap and water.
WARNING: Used oil and filters are dangerous
to the environment. Discard used chemicals at
an applicable disposal location.
CAUTION: Do not tighten the filter lid to much.
The filter lid is made of plastic.
40 - Repair instructions
This filter is behind the rear transmission and must be
changed when the oil is changed.
Obey the instructions in
clean on page 30 .
1. Drain the oil from the rear transmission. See
replace the oil in the front and rear hydrostatic
transmissions on page 39 .
2. Remove the filter lid and pull out the filter.
3. Push in the new filter until the rubber seal in the front
is in position.
To
4. Attach the filter lid.
Note: The filter is not in the correct position if the
spring must be compressed before the filter lid
thread connects.
To bleed
To keep the hydraulic system
420 - 002 - 22.03.2018
To