Husqvarna Rider 213C Workshop Manual page 18

9.1.2.2 To adjust the throttle cable
1. Loosen the clamp screw for the cable casing on the
throttle cable and move the throttle control to the full
throttle position.
2. Make sure that the throttle cable is attached to the
correct hole in the lower lever.
3. Pull the cable casing on the throttle cable away from
the hole and tighten the clamp screw.
9.1.3 Seat
9.1.3.1 To adjust the seat
The seat can be tilted forward. It can also be adjusted
lengthways. Loosen the handles below the seat to adjust
it forward or rearward.
9.1.4 Parking brake
9.1.4.1 To examine the parking brake on AWD products
WARNING: The parking brake function can
decrease if the parking brake is not correctly
adjusted.
1. Park the product on a slope with a hard surface.
18 - Repair instructions
Note: Do not park the product on a grass slope
when you do a check of the parking brake.
2. Press the parking brake pedal (1) down.
1
3. Press and hold the lock button (2).
4. Release the parking brake pedal while the lock
button (2) is pressed.
5. If the product moves, adjust the parking brake.
9.1.4.2 To adjust the parking brake on AWD products
1. Remove the left footrest plate. See
covers on page 17 .
2. Loosen the parking brake locknuts (A).
3. Turn the adjustment screw (B) until the cable is tight.
4. Tighten the locknuts.
5. Examine the parking brakes after adjustment. See
To adjust the parking brake on AWD products on
page 18 .
6. Attach the left footrest plate.
9.1.5 Wheel hub
9.1.5.1 To disassemble and assemble the wheels
CAUTION: The dimension of the spacers and
the number of washers can change between
2
To remove the
B
A
420 - 002 - 22.03.2018