Setting For The Connection With Fs-75/1562/5000 And Dp-6 - Furuno DSC-60 Service Manual

3.2 Setting for the connection with FS-75/1562/5000 and DP-6

TX/RX control data exchange between Furuno radio units are made normally by MIF protocol
through the RS-232C connections with factory-default setting.
When the interconnection cable is lengthened
MIF in the SYSTEM menu.
DSC-60
DSC-60
The DIP switches on CONTROL/MODEM board of DSC-60 are set as follows:
RT: Set S4.
(Selection of data format for the communicatin with RT)
- S4-1 and 2 : ON (RS-232C);
- S4-3 and 4 : OFF (RS-232C);
NBDP: Set S3.
(Selection of data format for the communication with NBDP)
- S3-1 and 2 : ON (RS-232C);
- S3-3 and 4 : OFF (RS-232C);
Note) Related settings
Pressing [#/SETUP] key reveals "Setup menu" screen. Select SYSTEM, and set RT
PORT and NBDP PORT.
- RT PORT
- NBDP PORT ->>> ON
Furthermore, priority setting must be made on FS-75/1562 (not necessary on FS-5000). See
page 2-17.
When NBDP port is not used, When NBDP port is not used, When NBDP port is not used,
When NBDP port is not used, When NBDP port is not used,
set set set "NBDP" set set "NBDP" of SYSTEM setting a "NBDP" "NBDP" "NBDP"
[RT]
#2-SD
#3-RD
[REM-B] [REM-A]
[NBDP]
DP-6
#2-SD
#3-RD
Connection with FS-5000 and DP-6
[RT]
#2-SD
#3-RD
[REM-B]
[NBDP]
DP-6
#2-SD
#3-RD
Connection with FS-75/1562 and DP-6
->>> MIF
of SYSTEM setting a of SYSTEM setting a of SYSTEM setting at OFF of SYSTEM setting a
, select C. Loop by S4, instead of RS-232C and
[REM-1/2/3]
[REM-1/2/3]
[REM]
DB-120
[REM-A]
OFF (C. Loop)
ON (C. Loop)
OFF (C. Loop)
ON (C. Loop)
t OFF t OFF t OFF. . . . . DIP s t OFF DIP switc DIP s DIP s DIP s
4-18
2. System setup(Setting DIP Swithes)
FS-5000C
REM-A
PCB
FS-75/1562
witch S3-#1 and #2 is set a witc witc witc h S3-#1 and #2 is set at ON h S3-#1 and #2 is set a h S3-#1 and #2 is set a h S3-#1 and #2 is set a t ON. . . . . t ON t ON t ON