Setting Functions (Functions Menu) - Furuno NX-300-D Operator's Manual

2.7

Setting Functions (FUNCTIONS menu)

See menu description below for detailed information.
1. Press the [MENU] key to open the main menu.
2. Press ! or " to select FUNCTIONS.
3. Press the [ENT] key to display the FUNCTIONS menu.
4. Press ! or " to select menu item and press the [ENT] key.
5. Press ! or " to select option desired.
6. Press the [ENT] key to register your selection.
7. Press the [MENU] key twice to close the menu.
2.7.1 FUNCTIONS menu description
RCV NOTIFY: The raw NAVTEX signal can be monitored through the monitor speaker by turning
RCV NOTIFY on. The default setting is OFF.
RCV ALARM: The audible alarm may be generated when message type A, B, D or L is received.
The default setting is ON.
KEY BEEP: The equipment can emit a beep tone when a control is operated. The default setting
is ON.
ERROR RATE: When character error occurs due to noise interference during signal propagation,
erroneous character is displayed as "∗".
Error Rate means character error rate and is calculated as followed:
Error Rate = number of erroneous characters ÷ total number of characters received × 100 (%)
(Total number of characters includes space, line feed, carriage returns, etc.)
When the character error rate is within the percentage you set (0-39%), the NX-300 displays the
message and stores it. When it exceeds the percentage you set, the NX-300 neither displays nor
stores the message. You may set the threshold level of character error rate as desired and the
default setting is 33%.
Figure 2-14 FUNCTIONS menu
2-5