Updating Main Program With Pc - Furuno DSC-60 Service Manual

3.3 Updating MAIN program with PC

1. Connect the PC to the DSC-60.
2. Turn on the PC, but do not turned on the DSC-60.
3. Insert the program floppy disk in the slot.
4. Type a: and press [Enter] to select drive A
5. Type "UPDSC" and press [Enter]. The following message appears.
Program upload utility Version 6.21
Copyright(c) FURUNO ELECTRIC CO., LTD.1997,1998,1999 (T.K)
uppg infile 1 infile 2 p1 p2 p4 p5
p1:Deletion waiting time.
p2:Waiting time to write.
p3:Password output interval.
p4:ID number.(1,2...)
p5:Poer number.(1,2...)
Erase Wait:osec
Wait:o
Wait counter=100
Port no.=1
TARGET POWER ON.
6. Turn on the DSC-60.
The indication on the DSC screen changes as below.
Execute STEP1
Execute STEP2
xxxxxByte transfer
Now Erasing
xxx percent completed
7. Wait for about 5 minutes until the xxx percent reaches to 100.
8. The DOS prompt appears after the message "Finish version up."
9. Turn off the DSC-60, disconnect the IB-581 and turn on the DSC-60 again.
10. Press [3/TEST/DEF] to perform the selftest and confirm the program has been updated.
7-18
3. How to update system program