Choosing The Local Frequency; Editing The Setting For Frequencies - Furuno NX-700A Operator's Manual

2.7

Choosing the Local Frequency

You can choose 490 kHz or 4209.5 kHz as the local frequency. This function is
only available for the Auto and Manual modes. (See paragraph 2.6.)
1. Press the MENU/ESC key to show the main menu.
2. Press ▲ or ▼ to choose NAVTEX, and then press the ENT key or ►.
3. Press ▲ or ▼ to choose Local Channel, and then press the ENT key or ► to
show the local channel options.
4. Press ▲ or ▼ to choose the frequency 490 kHz or 4209.5 kHz, and then
press the ENT key.
5. Press the MENU/ESC key several times to close the menu.
2.8 Editing the Settings for Frequencies
Stations and messages for receiving/displaying on each frequency can be edited
as below.
Rcv Station & Msg
(Station)
You can receive messages by station when Manual is chosen as the Receive
Mode on the NAVTEX menu.
(Message)
You can choose the messages to receive when Manual or Auto is chosen as the
Receive Mode on the NAVTEX menu. Note that A/B/D/L cannot be rejected.
User Select Station & Msg
(Station)
Choose the station to display on User Selected Messages, which is shown when
the LIST key is pressed.
(Message)
Choose the type of message to display on User Selected Messages, which is
shown when the LIST key is pressed.
Note 1: For messages, the alarm message is displayed always.
Note 2: When User Select is chosen as the Auto Print on NAVTEX menu, only
the messages chosen here are printed. (See paragraph 2-12.)
1. Press the MENU/ESC key to show the main menu.
2. Press ▲ or ▼ to choose NAVTEX, and then press the ENT key or ►.
490kHz
4209.5kHz
Local channel options
2. OPERATION
2-5