Acquiring The Image With The Camera - Olympus CX33 Instructions Manual

10

Acquiring the image with the camera

The observed image can be acquired by attaching the camera adapter and the digital camera for microscope to the
trinocular tube. (For attaching the camera adapter and the camera, see page 30.)
When using the camera adapter, be sure to adjust the parfocality. Otherwise, the image through
NOTE
eyepieces and the image acquired by the camera are not focused at the same position.
For procedures to adjust the parfocality, refer to the instruction manual of the respective camera
adapter.
b
a
Observation
range by
standard 10X
eyepieces
When using the camera adapter 1 x (U-TV1XC)
18
Rotate the light path selection knob a of the trinocular tube to move
1
it to
a
The image acquisition range is determined by the size of the
TIP
image sensor used in the camera and the magnification of
the camera adapter.
The comparison between the observation range by standard
10X eyepieces and the image acquisition range by the
camera is shown in the picture on the left.
a Digital camera for microscope (DP22)
b Digital camera for microscope (DP27)
position. (See page 9.)
Image sensor size (diagonal): 1/1.8-inch (9mm)
Image sensor size (diagonal): 2/3-inch (11mm)