Level 2 Display / Control Functions; Display Functions; Control Functions; Sound Alarms / Evacuate - Honeywell MORLEY IAS DX Series User Manual

Dimension Series

5 Level 2 Display / Control Functions

5.1 Display Functions

•
All of the display functions available at Level 1 are also available at Level 2.

5.2 Control Functions

•
The four main control keys are locked at Level 1 (Note: Mute Buzzer key is always enabled). To
enable the Level 2 control functions, press any control key and the following display will be shown:
CONTROL KEY LOCKED – ACCESS REQUIRED
Enter Level 2/3 passcode
•
Enter the Level 2 pass-code (for example, the default pass-code is 1234) using the number buttons.
As each number is entered, a '*' character is shown on the display. When all four digits have been
entered, press the ' ' key. (If a wrong number key is pressed, press the
entered and re-enter the correct / required number).
•
If the pass-code is correct, the display will revert to the normal display. Level 2 access will remain available
for 5-minutes (programmable). Press the required control to perform the desired action – see below.
•
If the pass-code is entered incorrectly, the display will show the following message for 60 seconds.
Press the 'X' button to revert immediately to the normal displays. The eight-character number on the
bottom line is a control code and is only relevant to Level 3 use.
ERROR – INCORRECT PASSCODE !!!
C8B0E488
•
Alternatively, if the key-switch option is fitted and programmed to enable Level 2 access, insert the key
and turn clockwise to enable Level 2 Control functions.

5.2.1 Sound Alarms / Evacuate

To activate all sounder outputs and evacuate the building press the SOUND ALARMS key.

5.2.2 Silence / Resound Alarms

To silence the sounder outputs press the SILENCE / RESOUND key.
To reactivate all silenced sounder outputs press the SILENCE / RESOUND key again.

5.2.3 Accept / Delayed Day Mode Alarms

If the system is programmed to operate with the Delayed Day Mode function the panel will
indicate the alarm but will not immediately activate the outputs (sounders or relays). Press the
ACCEPT key to acknowledge the alarm and enter the Investigation Phase – refer to Section 6
for further information.

5.2.4 Reset

To reset the panel from a fire alarm or fault condition, firstly correct and rectify the problem and
then press the RESET key. To prevent fault conditions being registered from faulty devices
disable the device – refer to the Enable / Disable Menu.
User Manual Document No.996-148-000-5, Revision: 5
MORLEY-IAS
←:BackSp
key to erase the number
Page 21