Fire Alarm Conditions; Panel Fire Alarms; Zone Fire Alarms - Honeywell MORLEY IAS DX Series User Manual

MORLEY-IAS

4.2.1 Fire Alarm Conditions

•
If the control panel initiates an alarm condition, the FIRE LED Indicators will be illuminated and, if
appropriate, the relevant ZONE FIRE LED Indicators will illuminate. The internal buzzer will sound and
the alphanumeric display will indicate the number of fires.
•
To view more detailed information regarding the fire alarm location use the navigation keys as follows.
•
Press the
following for example:
TOTAL PANEL FIRES
TOTAL ZONES IN FIRE
•
This display indicates that there are two zones in fire and that a fire alarm has been raised at the
panel. To view these, press the
to view the zones in fire.
4.2.1.1

Panel Fire Alarms

FIRE
EVACUATE
•
The above example shows there are one of one fire alarm raised at the panel. This was an "Evacuate"
raised at 11:22AM when the "Sound Alarms" key was pressed.
•
If there is more than one fire alarm indicated, use the
more' option is not shown if there is only one event, the '↓' and '↑' keys are shown for the first and last
entries in the list). Press the
4.2.1.2

Zone Fire Alarms

•
When selected, the display shows the first zone with a fire alarm condition. For example:
IN FIRE
<Zone-Location-Text>
•
The display shows the Zone number and Zone Location Text (20 character description).
•
To view other zones in fire (or to return to the previous display), press the
•
To view the devices (points) in a fire alarm condition, press the
first point in alarm in the selected zone. For example:
FIRE
<Point-Location-Txt>
•
The display shows the alarm number and the total number of devices (points) in a fire alarm condition in
this zone (01/02), the Zone number (Z04), the loop number to which this device is connected (L1), the
address of this device on the loop (A011), the type of device (MCP), the time at which the device entered
the alarm condition (11:45) and the Point Location Text (20 character description) for this device.
Page 12
keys to select the FIRES option, then press the
:1
:2
key to view the fire alarm initiated at the panel and press the
01/01
key to return to the previous display.
ZONE 3 1/ 2
01/02 Z04 L1 A011 MCP 11:45
Document No. 996-148-000-5, Revision: 5
key and the display shows the
→:Panel Events
↓:Zone Details
11:22
←:back
:more
and keys to view these (Note: The ' :
:More Zones
→:Device Details
key. The display then shows the
←:back
:more
Dimension Series
key
and keys.
User Manual