Display And Controls - Honeywell PL-1000 Installation And User Manual

9

DISPLAY AND CONTROLS

The Touchscreen display and LED indications, allow the user to review the system status and, with appropriate user PIN, have access and perform tasks in
accordance with the requirements of the local fire regulations. There are 13 status icons provided on the front panel and 4 push buttons for event conditions.
STATUS ICON CONDITION / CONTROL
FIRE
DISABLEMENT
TEST
POWER
FAULT
EARTH FAULT
SOUNDER FAULT /
DISABLEMENT
POWER SUPPLY FAULT
AUXILIARY POWER SUPPLY
OUT FAULT
SYSTEM FAULT
M-169.1-SERIE-PL-EN / 09.2022
COLOR
Red (blinking)
Red (fixed)
Yellow (blinking)
Yellow (blinking)
Green (fixed)
Yellow (blinking)
Yellow (fixed)
Yellow (blinking)
Yellow (fixed)
Yellow (blinking)
Yellow (fixed)
Yellow (blinking)
Yellow (fixed)
Yellow (slow blinking 1sec On, 1sec Off) Battery charger fault or Battery resistance fault condition is present
Yellow (blinking)
Yellow (fixed)
Yellow (fixed)
Fire Alarm Control Panel PL-1000
DESCRIPTION
A fire condition has been detected (buzzer active)
The user has acknowledged the event by buzzer silence
A device or zone is disabled
A zone is in test mode
The system is switched on and the power is supplied via the mains
General fault, buzzer is active
The user has acknowledged the event by buzzer silence
Earth fault condition is present
The user has acknowledged the event by buzzer silence
Sounder fault condition is present
Sounders circuits are disabled
Mains fault
Batteries fault
24 Vcc user fault condition is present
The user has acknowledged the event by buzzer silence
System fault
25